Rolling In or Out
From CTH Drafting Standards
When changing a wall from siding to brick or from brick to siding you may be asked to "Roll the Wall In" or "Roll the Wall Out". This may affect the Area calculations. There will be times when you can not roll in or out some of the walls due to constraints of the project.
Rolling In
When asked to roll the wall in use the following Wall Alignment options.
Brick to siding:
- Brick Wall select Outside of Current Wall's Outermost Bearing Material
- Siding Wall select Outside of New Wall's Outermost Bearing Material
Siding to brick:
- Siding Wall select Outside of Current Wall's Outermost Bearing Material
- Brick Wall select Outside of New Wall
Rolling Out
When asked to roll the wall out use the following Wall Alignment options.
Brick to Siding:
- Brick Wall select Outside of Current Wall
- Siding Wall select Outside of New Wall's Outermost Bearing Material
Siding to Brick:
- Siding Wall select Outside of Current Wall's Outermost Bearing Material
- Brick Wall select Outside of New Wall's Outermost Bearing Material
