Wall definition question

You are here

3 posts / 0 new
Last post
Kelly Strickland
Kelly Strickland's picture
Wall definition question
SoftPlan Version:
2014 Plus

I don't recall any issues with this until now and not sure if it is something with 2014. I'm attempting to adjust a tile surround and can't get the tile to adjust to the correct height. The wall is 9' and trying to make the tile shower at 8'. I can get the tile to adjust some, just not to the correct height. I've tried checking/unchecking "fixed". Any ideas?

Thanks,

Kelly

Bill Wimberley
Bill Wimberley's picture
Tile

Perhaps rather than doing this using a wall you could try using a Wallcovering.

Switch to Interior mode. From the Draw tab select Wallcovering. Select Tile. Select either Manual or Autotrace, depending on the situation. After you draw the tile wallcovering edit and uncheck "Full Coverage". Enter in the height you want the tile to be.

Bill is the owner and maintainer of SoftPlanTuts.com

Kelly Strickland
Kelly Strickland's picture
Bill, thanks. I think SP made

Bill, thanks. I think SP made a change with the wall defs in 14. I saw something about it on another post. I initially tried using an 8' tall baseboard but the opening did not cut through it. Your solution, as usual, works like a charm. Many thanks!