Sloped ( Tapered ) Wall

You are here

2 posts / 0 new
Last post
jimcrook@live.com
jimcrook@live.com's picture
Sloped ( Tapered ) Wall
SoftPlan Version:
2014 Plus

What is the best way to create the sloped ( tapered ) conc. wall shown in the pic below ?    I intend to just slide this up against

the plumb framed wall.  In other words I'm not trying to create an entire wall assembly just the angled conc. part on the lower

3' or so of the assembly.

 

 

Thanks

JimC

 

 

Bill Wimberley
Bill Wimberley's picture
Tapered Wall

I've done that before by creating a profile and including that profile in the wall definition.

You could also take the same profile and use it as a profile for banding.

Bill is the owner and maintainer of SoftPlanTuts.com