Help with a roof

You are here

4 posts / 0 new
Last post
Bill M
Bill M's picture
Help with a roof
SoftPlan Version:
2014 Plus

This one should be easy but for whatever reason the solution eludes me.  Different wall heights are in play but again, shouldn't matter.  I have attached the plan if anyone would be good enough to take a look.  It is the back right portion of the roof.  Thanks.

AttachmentSize
Binary Data Main Floor 4-15 roof problem.spd157.47 KB
jimcrook@live.com
jimcrook@live.com's picture
Roof

Bill, I just tried it and what I did was erase the entire roof and retrace the roof but leave out the little bathroom at the right rear.

In other words just continue to follow along the line of the patio beam all the way to the right side of the house.  This will put the

roof on minus the little bit over the bathroom bumpout.  Then trace the bathroom bumpout.  In my case the left most lollipop for

some reason generated as a Gable, so I just changed that to hip and voila your good to go.

 

JimC

yvongonthier
yvongonthier's picture
Roof

Your roof at your problem area is set at gable instead of hip.

Bill M
Bill M's picture
Jim, Yvon, thank you both

Jim, Yvon, thank you both very much.  I knew it was something simple but did not check that edge.  Changed it on my end and did exactly what I needed it to do and what I had drawn by hand.