Electrical Symbols

You are here

3 posts / 0 new
Last post
DamonB
DamonB's picture
Electrical Symbols

Hi,

I'm trying to make several new light symbols.

I would like the insertion point to be the middle of the circular symbol not the bottom of the symbol. I do have a construction point in the middle as well.

Any suggestions would be greatly appreciate before I insert and then also move this symbol 500 times.

 

Thanks

Bill Wimberley
Bill Wimberley's picture
Electrical Symbols

You can do this with V2012. When defining your Electrical Symbols place a check on "Anchor at Center".

 

Bill is the owner and maintainer of SoftPlanTuts.com

DamonB
DamonB's picture
Electrical Symbols

Thanks a bunch Bill.

I never would have looked there to specify an insertion point.