Change dimension to rough openings?

You are here

3 posts / 0 new
Last post
JasonDentDesign
JasonDentDesign's picture
Change dimension to rough openings?
SoftPlan Version:
2014 Plus

Where do I find ( I'm sure it is here) options to have dimensions take offs from rough opening edges and not at center of the opening as it currently is? Thanks

yvongonthier
yvongonthier's picture
Extension options

In your system or drawings options under by double clicking on it to expose the list for dimensions, extensions and opening options. Under , in the tab beside you can select frame, center or rough.

JasonDentDesign
JasonDentDesign's picture
Great thanks. One must also

Great thanks. One must also know that if you change your system settings mid stream of a project they will not reflect in the drawing until you "reset to system" in drawing settings. This must be done for each type of setting. Thought I'd throw that in for others just as a tip!! Thanks again.